Recommended faux fur care:
Hand wash or machine wash with cool water only. Allow to air dry or use no-heat tumble dry if using a dryer. Excessive heat will ruin and melt the fur!
How to remove creases:
1. Lay the fur piece out on a flat surface.
2. Using a hairdryer on medium heat, blow the fur fibers in the direction of the pile. You may want to use a slicker brush to help straighten the fibers.
3. After a few seconds of heat, the fibers should mostly straighten back out. Repeat over the rest of the piece and it should be mostly fixed. WARNING: Don't hold the hairdryer for too long in one spot - this will cause the fibers to MELT which will permanently ruin the fur.
**Note: This fur is a little different from most of our shags - the pile is longer and the backing is a little thinner. Order swatches if you're unsure about this for your project! :)**
This extremely high quality and very soft fur is perfect for use in fursuits, and is used by most professional makers. Also called DF fur, DF shag, promo shag, luxury shag, and punky muppet.
This fur has approximately a 2" pile, and comes in 1 or 1/2 yard increments. Yards average 60" in width. This fur can be used on any part of a fursuit, but is rather long so will need to be shaved down using pet clippers on shorter fur areas, such as the face of a fursuit.
Want to purchase a half yard? Simply enter "0.5" in the quantity box and add the item to your cart. You can also enter 1.5, 2.5, 3.5, etc depending on how many yards you would like. Any number ending in .0 or.5 is acceptable.